Adjustable humidity and extra cooling power. Replaces Breezaire 2200 and Wine-Mate 2500 cooling units.
CellarPro's 1800XT wine cooling unit provides outstanding performance, adjustable humidity control and extra cooling power. The CellarPro 1800 is quite good for small wine cellars and slightly larger wine cabinets that are located in warmer environments and/or used by commercial establishments. The CellarPro wine cooler products are designed to be installed through the wall and should not be ducted unless accompanied by an in-line fan. CellarPro 1800XT wine cooling units can be used immediately to replace Breezaire 2200 and Wine-Mate 2500 cooling units.
Capacity: 250 cubic feet in properly insulated and sealed wine cellars.
We offer an extended warranty with enhanced coverage for our 1800 Series cooling units.
- Electronic Thermostat
- Digital LED Display
- Adjustable Humidity Control
- Energy-Saver Mode
- Quick-Chill Mode
- Audible and Visual Alarms
- High-Output Compressor
- Electrofin Coated Coils
- Min/Max Temperature
- Maintenance-Needed Indicator
- Auto-Defrost Cycle
- Ultra-Quiet Operation (< 50 dBA)
- Power On/Off Switch
- Removable Steel Case
- Power Cord Exits from the Rear
- Vibration-free Operation
- 3-Amp light Receptacle
- Optional Extended Warranty
When ducting the FRONT of CellarPro VS and Split cooling units, varying amounts of condensation can occur depending on the ambient conditions where the cooling unit will be located. The charts above are designed to provide guidance in selecting the appropriate front duct kit depending on 1. Your desired cellar temperature, 2. The ambient temperature where the cooling unit will be located, and 3. the ambient relative humidity where the cooling unit will be located.
Condensation generally occurs on the cold surfaces of the face and around the front of the cooling unit when the temperature of the metal falls below the ambient dew point (a function of temperature and humidity). The greater the difference between the dew point and the metal temperature (ie the higher the dew point and the lower the metal temperature), the more condensation will occur.
For this reason, CellarPro has developed two front duct kits for its VS and Split systems: a duct kit for LOW humidity conditions, and a duct kit for HIGH humidity conditions. The HIGH humidity duct kit has extra insulation around the front and face of the cooling unit, and always should be used together with our remote control display kit. In some cases (shown above in red), the humidity conditions are too high even for our HIGH humidity duct kit. In this case, the cooling unit should be moved to a conditioned space and the rear should be ducted if necessary.